Embedian, Inc.
21
SBC-SMART-MEN User’s Manual Document Revision v.1.0
RESET: Location on Board, G1
RESET
Hardware Reset
Setting
Function
Shunt RESET and Release
Immediately
Hardware Reset
WDT: Location on Board, H1
WDT
External Watchdog Timer
Setting
Function
WDT Open
Disable External WDT
WDT Closed
Enable External WDT
2.1.4. Setting Jumpers
You configure your board to match the needs of your application by setting
jumpers. A jumper is the simplest kind of electric switch. It consists of two
metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper you connect the
pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three
pins, labeled 1, 2 and 3. In this case you would connect either pins 1 and 2
or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
