EPSILON5 MKII Programmer - User Guide V1.12 – 1
st
August 2007
5
1.5 Programmer Specifications
1.5.1 Programmer Specifications Overview
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
Parameter
Description / comment
Refer
to
section
1 Target
Device
Support
See Device Support List
1.6.1
2 Target
Device
Programming
Interfaces
The programmer supports the following programming
interfaces:
•
Atmel Low Voltage SPI
•
Atmel High Voltage SPI (+12V Vpp)
•
Atmel AVR JTAG (chargeable update)
•
Atmel (formerly Temic) 8051 Boot loader ISP
NXP (Phillips) 8051 - Boot Loader ISP
1.6.2
3 Operating
modes
The programmer supports the following operating modes:
As standard:
•
Development Mode (PC controlled)
•
Project Upload Mode using Upload Wizard (PC
controlled)
•
Standalone Mode - LCD operation
•
Standalone Mode – Run Target
•
ConsoleEDS EVAL – Command Line control
Optional chargeable upgrades:
•
Standalone Mode - Remote Controlled via ‘ASCII Text
Communications’ RS-232 Serial Protocol
•
PC controlled via ISP-PRO software (chargeable
upgrade)
ConsoleEDS PRO – Command Line control
2.4
4 On-board
FLASH
Memory Store
2 Mbits (256 kBytes) FLASH Memory
5
Project storage in
Memory Store
1 x Programming Project
or 2 x ‘Chained Projects’
6 Keypad
entry
2 x Push Button - <YES> and <NO>
7 Status
LED’s
3 x Status LED’s - <PASS>, <BUSY>, <FAIL>
8 Target
Vcc
Voltage Detection
LED
•
Target Vcc (POWER) LED will light when Target Vcc is
detected.
•
Threshold detection voltage: approx 3.1V
