19
3 SAFETY SIGNS
1. Keep safety signs clean and legible at all times,
2. Replace safety signs that are missing or have become illegible.
3. Replaced parts that displayed a safety sign should also display the current sign.
4. Safety signs in Section 3 each have a part number displayed with it. Use this part number when
ordering replacement parts.
5. Safety signs are available from your authorized Distributor or Dealer Parts Department or the factory.
Z94120
Z94116
Z94127
Z94117
Z94115
Caution:
keep hands and feet out of inlet
and discharge openings while machine is
operating to avoid serious personal injury.
Wait for all moving parts to come to a com-
plete stop before clearing obstructions .
Caution:
Do not operate machine
without shields in place . failure to do
so may cause serious injury or death.
Caution:
pulley and belt entanglement
danger present, keep hands, loose
clothing, and long hair away from mov-
ing parts.
Caution:
flying objects, be aware of
and stay clear of material discharge
chute, machine can expel wood chips
fast enough to cause injury.
Do not point discharge at people, ani-
mals or buildings.
Caution:
do not refuel the machine
while smoking or when near open
flame or sparks. Fuel is highly flamma
-
ble, handle with care.
Z94119
Caution:
read and understand ALL
safety and operating instructions
in
the manual, read and understand ALL
safety labels
located on the machine.
The most important safety device on
this equipment is an informed SAFE
operator.
3.2 SAFETY SIGN EXPLANATIONS:
3.1 HOW TO INSTALL SAFETY SIGNS:
• Be sure that the installation area is clean and dry.
• Be sure temperature is above 50°F (10°C).
• Determine exact position before you remove the backing paper.
• Remove the smallest portion of the split backing paper.
•
Align the sign over the specified area and carefully press the small portion with the exposed sticky
backing in place.
• Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.
• Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper
Z94207
Caution:
Do not step into or place any
part of your body inside the feed hop-
per, failure to do so may cause serious
injury or death.
Z94167
Caution:
Hydraulic fluid under pres
-
sure, do not check for leaks with you
hand or fingers when the system is
pressurized. Serious injury will result.
Z94143
Caution:
When the chipper is running,
noise levels around the machine could
reach 121 dB, hearing protection is
required at all times.
Z94124
Caution:
Pinch Hazard
,
do not reach
into the machine while it is running,
some components may move unex-
pectantly and cause pinching , crush-
ing injury.
Summary of Contents for Wallenstein CR Series
Page 69: ...69 ...