Emax Yin Yan, User Instruction, Page: 5 / 5

E
MAX YIN YAN MODEL TECH.MFT.
G. Programming via Transmitter
2. Select program parameters
There’re 9 parameters can be set by using your transmitter. You would hear 9 different indicating sounds
which correspond to 9 different parameters. Pull the throttle stick to the bottom position (full Off throttle)
within 3 seconds after you hear the correspondent sound will brings you to the correspondent parameter
setting status. The indicating sounds will repeat in turn as follow (1 long sound=5short sounds):
1. “beep-” (a short sound) which indicates the
Brake Type
2. “beep-beep-” (two short sounds) which indicates the
Timing Mode
3. “beep-beep-beep-” (three short sounds) which indicates the
Start Mode
4. “beep-beep-beep-beep-” (four short sounds) which indicates the
Cutoff Mode
5. “beep-----” (a long sound) which indicates the
Throttle Curve Mode
6. “beep-----beep-” (a long sound and a short) which indicates the
Li-XX Cells
7. “beep-----beep-beep-” (a long sound and two short) which indicates the
Cutoff Voltage
8. “beep-----beep-beep-beep-” (a long sound and three short) which indicates
Motor rotation
reversible.
9. “beep-----beep-----beep-----“(three long sound)
EXIT.
1. Enter program
mode
Push the throttle stick to
the top position (full On
throttle), turn on the
transmitter, connect the ESC,
wait 2 seconds, you will hear
two “beep” sounds which
means the full On throttle is
confirmed. Wait another 6
seconds, it will make “ ♪ i 3 i
3” tune, then you can start
programming via transmitter.
3. Select program values
After entering parameter setting status, you will hear the ESC making sounds in cycle. Different sounds
indicate different values. Push the throttle stick to the top position (full On throttle) within 3 seconds after
you hear the correspondent sound, then you will hear a special tune “ ♪ 5 6 5 6”, which means the
correspondent value has been chosen and saved. If you don’t want to continue setting other values, just pull
the throttle stick to the bottom position (Full Off throttle) to exit. Or wait 3 seconds to return to the second
step and continue programming.
sound
Parameter
“beep-“
1sound
“beep-beep-“
2 sounds
“beep-beep-bee
p-“3 sounds
“beep-beep---
“x sounds
Brake Type OFF Soft Hard
Timing Mode Low Mid High
Start Mode Fast Soft Very soft
Cutoff Mode Soft-Cut Cut-Off
Throttle Curve Curve1 Curve2 Curve3
Li-XX Cells Automatic 2 cells 3cells xx cells
Cutoff Voltage
Low
（
2.6V
）
Middle
（
2.85V
）
High
（
3.1V
）
Motor rotation Normal Reverse
Remarks: Under
Li-XX Cells
value status, when the number of Li-xx battery cell is more than 4, the ESC
will indicate by making long “beep” plus short “beep” sounds, a long “beep” sound equals 5 short “beep”
sound. E.g. you will hear “beep-----beep-” (a long sound + a short sound) if there is a 6-cell Li-xx pack and
you will hear “beep-----beep-----beep-” (two long a short sound) for a 11-cell Li-xx pack.
4. Exit program
Exit programming: Two
ways as shown in step2
and step3.
5