For a correct installation, follow the recommendations
listed below:
3. Installation guide
•
Follow the arrangement shown in
2.Facility
scheme
•
Once you have located the dispenser, make
sure that the length of the hoses allows to reach
the facility pipes.
•
Drill a 10mm hole in the filter outlet pipe. Remove
burrs and debris.
•
Next, present the gasket and place the saddle
clamp with the adaptor, as shown in the
following figure:
Go to Index
•
Tighten the whole assembly and make sure you
have connected the flexible hose to the saddle
fitting adaptor.
•
Repeat the same procedure for the outlet pipe, as
indicated in
2.Facility scheme
•
Once the two connections are fixed to the pipes,
connect the free ends of the hoses to the inlet
(E)
and outlet
(F)
of the dispenser.
Summary of Contents for CL-01A
Page 1: ...Chemical feeder CL 01A User Quick Guide...
Page 10: ......