TYPICAL INSTALLATION EXAMPLE P16
4
Flow meter checks the amount of pumped liquid
DN
DN1
1
2
3
Diameter of inlet and outlet of the pump
Diameter of the Pipe
Air-bleed hole should be installed at the highest point
Holding the pipes with racks so as to prevent too much load on the branch of the pump, and the racks should be
coated with corrosion resisting material.
The water outlet pipe delivers the pumped liquid to a liquid storage layer, and the current velocity shouldn't
exceed 5m/s
5
6
7
8
Comparing with tight bending radius, the pressure loss of the loose bending radium is relatively low, which can
prevent the forming of cavitation.
The water outlet entrance is the terminal of the water outlet pipe; before starting the water pump, the water
pump and water inlet pipe should be firstly filled with water
The bypass ensures the minimum flow of the pump and delivers liquid to liquid storage container or water inlet
pipe.
Sluice valve departs the pump from the pipes
10
11
12
13
Check valve can protect the water hammer that formed in the process of operation of the pump so as to prevent
the draining-off of the water outlet pipe after the pump is stopped
The soft connection can prevent the forming of cavitation
Pressure gauge can check the working pressure
Drain plug for drainage and air-out
9
Sluice valve allows the adjustment of the flow of the pump
The water outlet entrance is the terminal of the pump and connects with the water outlet entrance
The water inlet entrance is the terminal of the pump and connects the water inlet pipe
The transition pipe should be flexible so as to prevent the forming of cavitation
14
15
16
No
.
Descriptions
The soft connection can prevent the forming of cavitation
Vacuum Gauge is to measure the suction pressure
Sluice valve departs the pump from the pipes
Holding the pipes with racks so as to prevent too much load on the branch of the pump, and the racks should
be coated with corrosion resisting material.
The aim of the water inlet is to deliver the liquid to the pump, so when installing it, tr y to make it short and
straight.
Steel reinforced concrete bottom ensures the stability of the pump
The plastic cushion is used to cushion the force between the reinforced concrete base and the pump base.
Explosive screw used to stabilize water pump
17
18
19
20
21
22
23
24
