eMachines DUV1000, User Manual

Page: 13 / 24

DUV1000 User’s Guide
13
Note:
¾ If power goes off while you are configuring, the phone will work with the previous saved
parameters.
¾ If you idle more than 90 seconds, DUV1000 will accept the keys entered and go to next
state.
¾ If you leave the phone without completing the configuration it will go back to idle state
without saving the parameters.
6.1 ISP Parameters
DUV1000 needs to connect to the Internet to make Internet phone calls. The following information
should be configured in DUV1000 to connect to the Internet and make calls. The user will get this
information while subscribing to Internet Service Provider (ISP). Please note that DUV1000 will
not work without this information.
ISP Phone Number
This is the phone number to which DUV1000 will dial-up to connect to the Internet. The Internet
access phone number can be maximum 20 digits. If you enter more digits and try to save, you will
hear a prompt “The parameter you have entered is incorrect, Press ‘1’ to edit, ‘2’ to skip”. Press
‘1’ or ‘2’ appropriately.
DUV1000 normally dials out with DTMF tones. However, if Internet access phone number is
configured to start with a ‘$’, then the phone dials out in pulse mode.
DUV1000 supports a mode called blind dialing mode. In this mode, DUV1000 won’t look for dial
tone on line before dialing the ISP number. User can enter '&' (Ampersand) as first character in
ISP Phone number (or as second character if first character is '$' for pulse mode dialing) for
dialing ISP number in blind mode.
Warning: In blind dial mode DUV1000 won’t prompt any error messages related to line conditions.
DUV1000 has special supports for operation behind an EPABX. In some scenarios, you may
have to introduce a delay after dialing external access number or wait for secondary dial tone. A
‘.’ (dot) in phone number will introduce a delay and a ‘_’ (under-score) will look for secondary dial
tone. For example, 9.6788341 will introduce a small delay after dialing 9, before dialing other
digits.
ISP User Name
The user name identifies the user to Internet Service Provider (ISP). It can have a mix of digits,
lower and upper case letters, and special characters. The user name can have a maximum of 30
characters. Please refer to Appendix A: Procedure for entering alphanumeric and special
characters to enter special characters.
ISP Password
The password used for verifying the user to Internet Service Provider (ISP). It can have a mix of
digits, lower and lower case letters, and special characters. It can have a maximum of 30
characters. Please refer to Appendix A: Procedure for entering alphanumeric and special
characters to enter special characters.