1
2
3
4
5
Temperature
mode interface
Time setting
interface
Current shift
interface
Accumulated electricity
setting interface
Accumulated electricity
setting interface
Charging standby
interface
Charging waiting
charging interface
Fault pause
interface
Locking plate
Allen screw
Wall bracket
The high-resolution color display of the EM2GO charging unit shows you the
following information:
1.
Current voltage
2.
Charging power per hour
3.
Charging time
4.
Charging temperature
5.
Current
6.
Charge indicator
LED strip display
The LED strip signals the status of the charger:
1.
No LED indication: Not in operation.
2.
LED permanently green: Charger is connected.
3.
LED green running: Charging in process
4.
LED permanently green: Charging process complete
5.
LED flashes red: There is a defect.
NOTE:
If the LED strip flashes red, the protection electronics of the EV charger was
addressed. In this case, please disconnect the mobile charger from the electric vehicle and
from the power grid. Submit the connections, cables and charger to a visual inspection.
If there are no visual defects, reconnect everything. If the red LED continues to flash, dis
-
connect the charger from the electric vehicle and the mains supply and contact your specialist
consultant.
Do not use the EV charger.
Adapter
Through the included adapter kit, you can charge your vehicle at almost any type of outlet.
The following adapters are included:
• CEE red 32A three-phase
• CEE red 16A three phase
• CEE camping max 16A
• Euro Schuko plug 16A single phase
• UK plug 13A single phase
Operating instructions / Vehicle charging
• Select the appropriate adapter for the power outlet to be used and connect it to the adapter
port of the mobile charging unit. Arritate the connector so that both metal hooks are fully
engaged. For safety‘s sake, pull lightly on both ends of the connector to make sure that it is
properly locked in place.
• Now connect the mobile charging unit to the mains socket.
• Pre-settings can now be made in the display. (See LCD status display)
• Next, connect the Type 2 plug to the charging port of your vehicle.
• Please note that the vehicle is prepared and set for the charging process.
The charging process will begin.
• When charging is complete, first remove the Type 2 plug from the vehicle, then disconnect
the charging unit from the mains.
NOTE: The charger unit is equipped with a residual current device (Type A RCD +
6mA DC). Please ensure that your three-phase power outlet is equipped with suitable
residual current device.
Wall mount:
The scope of delivery includes a wall bracket for the
charging unit, as well as screws and dowels for
mounting. To separate the wall bracket from the
charging unit, loosen the Allen screws on one of the
two locking plates on the front sides of the wall
bracket and remove the locking plate.
Now you can slide the charging unit out of the
wall mount.
GB
5
