9
Set simple printing parameters according button operation. There are two methods of
entering into parameter setting mode, which can set different parameters.
A. Under the state of power off, hold down the
【
MODE
】
button then press the
【
POWER
】
. Then loosen the
【
POWER
】
button and
【
MODE
】
button orderly when
you hear ‘one low one high prompt tone and LCD shows “Loading...”. The printer turns
into the parameters setting mode. Press the
【
FEED
】
button or
【
MODE
】
button, LCD
shows the first item which can be set parameters and the current numerical value.
(Refer to Appendix A.)
Quitting parameter setting:hold down the
【
MODE
】
button, press the
【
FEED
】
buttons,
then loosen
【
MODE
】
button and
【
FEED
】
button. Saving the set parameter and
exiting the parameter setting mode. The setting parameters won’t be saved if you
directly press the
【
POWER
】
button to turn off the printer.
B. Under the state of standby power, press the
【
MODE
】
button to enter the parameter
setting mode. Use the
【
MODE
】
button and
【
FEED
】
button in combination.Press the
【
MODE
】
button to select the setting parameter item, and use the
【
FEED
】
button to
select the sub-menu of parameter item.(Refer to Appendix B.)
Wait for 5 seconds to save parameters value and quit the setting mode automatically.
3.2.7 Battery Charging
The battery will run out after a period of usage. When it nearly runs out, printer will give
a alarm through the battery indicator flashing on LCD, at this time, user needs to
charge up the battery
The charging method is as following: connecting the adapter to the power socket with
220V, 50HZ, then plug the power charging plug to the power socket of the printer, so
the power charging begins. During the course of power charging, the charging
indicator
【
CHARGE
】
goes red, and
【
CHARGE
】
turns to green when the charging is
full.
Please don’t use printer when it’s charging.
3.2.8 Set Into Upgrading Mode
In the status of power off, press the
【
MODE
】
button and
【
FEED
】
button, then press
the Power button, hear ‘one low one high ’prompt tone, loose all the button
immediately, then the printer enters upgrading mode, the LCD shows upgrading mode.
Please note that only USB interface can support online procedure upgrading.
3.3 Printer Parameters Setting
