TECHNICAL DATA OF THE FEED BOARD
Board feed: pre-cabled, powered by standard PoE 802.3af (48Vdc)
Input power of the heating: 3,5W
INSTRUCTIONS FOR THE CAMERA SETTING
1)
Fix the bracket in the required position (1) (fig.1) by means of screws of diam. 8 mm with special small
blocks.
2)
Unscrew the screws of the left side (2) (fig. 2) and open the housing. The topo cover has a rotation
of 180°.
3)
Insert the Ethernet cable through the bracket (1) (fig. 1).
4)
Connect the electrical connections (fig.4) following diagram on right side.
5)
Unscrew the 4 fastening screw of internal slide and remove it by movement on rear direction (fig.3).
6)
Install the camera in the required position and fasten it by means of the special screw and insula-
ting washer(fig.3), then fasten the 4 screw of internal slide.
7)
Connect the electrical connections between feeding board and camera and make sure that you are
using the correct voltage.
8)
Close the housing by following the opening opposite procedure and fasten the 2 screws on the left
side of housing then clamp appropriately the cable-press device.
NOTE
For adjusting the lens with the window of the housing, make the following:
5.1) Unscrew the 4 fastening screw of internal slide (4) and remove it by movement on rear direction and
remove it definitively.
5.2) Unscrew the 2 fastening screws of internal slide (5) and remove it by movement on rear direction.
6.1) Install the camera in the required position and fasten it by means of the special screw and insula-
ting washer (fig.3), then fasten the 2 screws of internal slide (5).
WARNINGS
BEFORE APPROACHING THE CONNECTING DEVICES, ALL OF THE FEED CIRCUITS
MUST BE DISCONNECTED.
Make sure that at the beginning of the equipment there is a suitable sectioning device having a minimum
distance of the contacts of 3 mm.
THE INSTRUCTIONS MUST BE KEPT FOR FUTURE USE.
3/8
5299/POE
GB
