GB
43
Installing your new appliance
Ventilation
To maximize the efficiency of the refrigeration system and
save energy, it is important to maintain good ventilation
around the appliance so that heat is carried away. So make
sure there is adequate free space around the appliance.
Recommendation: We recommend there is at least 75 mm
clearance at the rear, at least 100 mm above the appliance,
50 mm at the sides and enough free space in front to allow
the door to be opened through 135°. See the following
images.
ุ
100mm
1855mm
ุ
mm
ุ
50mm
ุ
50mm
1220mm
PP
712mm
Important!
This device is intended for use in climate class SN, N, ST,
T (+10–43° C). The appliance may not operate correctly
if it has to run for a long time at a temperature outside the
specified range.
Important!
•
Install the appliance in an area with low humidity.
•
Protect the appliance from direct sunlight, rain and frost. Install
the appliance well away from heat sources, such as an oven,
stove or heater.
Installing in pairs
•
Two appliances can
be installed as a pair, as illustrated.
•
The appliances can be installed as shown, with the
handles in the middle.
Levelling the appliance
•
It may be necessary to adjust the feet so that the
appliance stands vertically, with adequate room for
ventilation. You can adjust the feet by hand, or with the
aid of a suitable open-ended spanner.
•
To ensure that the door closes by itself, adjust the feet
so that the top of the appliance leans backwards by
around 10 mm.
İ
10mm
Fitting the door handle
The door handle is supplied in a separate plastic bag to
simplify transport. Fit the door handle as follows.
1. Place the handle at the edge of the door as shown in
the diagram, with the holes lined up with the screw
holes in the door.
2. Secure the handle with the screws provided.
