15
chill display can only appear if the wind sensor S 2010 W is a component part of
the weather station.
After pressing the ‘Outdoor’ button again, the display returns to the normal tem-
perature display.
4. Program Mode
Programming mode can be used to set the maximum and minimum values for the
alarm function.
Please note that the row of labels underneath the buttons applies and that if no
button on the unit is pressed within 60 seconds, it returns to normal operation
mode.
Activate Program Mode by pressing the ‘<-’ and ‘->’ buttons simultaneously.
PROGRAM MODE appears in the display together with the set minimum alarm
values. The weather symbols, air pressure tendency air pressure history and wind
rose are deactivated.
After pressing the Min/Max button, the maximum alarm values appear. If the Min/
Max button is pressed again, the minimum alarm values reappear. The alarm valu-
es, e.g. rising or falling below a certain ground temperature, exceeding a specific
wind strength etc., can now be adjusted in programming mode.
4.1. Setting the alarm min./max. values
Use the two arrow buttons ‘<-’ and ‘->’ buttons, and the ‘Sensor’ button, if neces-
sary, to select the required measuring point or quantity.
Min/Max selection
The ‘Min/Max’ button is used in this mode to enter the minimum and maximum
values as required. The button function and function sequence corresponds to that
described in Section 3.4 ‘Min/Max Function’. Firstly, all the minimum then all the
maximum values can be entered or each measuring site can be assigned a mini-
mum and maximum value directly.
Set values
Use the ‘+’ and ‘-’ buttons to set the required numeric value. Keep the button
pressed and the unit automatically increases or decreases the value correspondin-
gly.
Increase counting speed
By pressing the ‘Fast’ ‘+’ or ‘-’ buttons simultaneously, the counting factor is
increased by 10.
4.2. Calibration mode
Calibration Mode enables settings to be defined which only needs to be carried out
once. It is used to calibrate the height compensation for baromeric air pressure,
balancing the rainfall transmitter and to set the required measuring units for air
Summary of Contents for WS 2010
Page 2: ...2...
