2
Control panel
Button Description
Display
Button
Usage
Function
Description
1. Plug in the power supply and it enters standby mode. Press this button to start the fan.
During the first use, the startup wind speed is “1”. If the fan is turned on again after
standby mode, the fan defaults to the wind speed that was last used.
2. When the fan is running, press this key again to stop the fan.
1. When the fan is running, you can set the timer to off the fan. When it is in standby,
you can set the timer for the fan to be powered on after appointed time.
2. Press this button to set the on/off timer for the following duration cycle (1h – 2h –…
5h – 6h – cancel timer – 1h – 2h…)
3. After the timer/reservation time is set, the wind speed and timer are displayed alternately;
when "h" light is on, the timer duration is displayed; when "h" light is off, the speed
is displayed.
4. The timer function can only set the appointed time to switch on the fan; the wind speed
and oscillation settings cannot be pre-set.
In the power on state, press this button to turn on/off the head oscillations.
When the fan is running, press this button to toggle the wind speed in the following cycle
(1-2-3-1-…)
Note:
1. Short press this button to adjust the wind speed, long press this button to change the mode.
2. When the fan is running, press this button to toggle the wind speed in the following cycle (1-2-3-1…); the
corresponding speed indicator will be on.
3. When the fan is running, press and hold this button to change the wind mode; Press and hold to toggle between
these modes (Whirlwind - Natural wind - Baby wind - Normal mode – Whirlwind….) The default is normal mode.
The wind speed can only be adjust in normal modes, and not in other wind modes.
