www.prolight.co.uk
Evora 850 Zoom Spot
User Manual
10
Operating instructions
Operating instructions
Error Code
Description
Pan
The PAN movement is not located in the default position after the reset. This message will appear
if the sensor has failed or magnet is missing, or if there is a motor failure (defective motor or
a defective motor IC drive on the main PCB). This error may also be displayed if the yoke was
blocked during a reset function.
Tilt
The TILT movement is not located in the default position after the reset. This message will appear
if the sensor has failed or magnet is missing, or if there is a motor failure (defective motor or
a defective motor IC drive on the main PCB). This error may also be displayed if the head was
blocked during a reset function.
Colorwheel
The colour wheel is not located in the default position after the reset. This message will appear
if the sensor has failed or magnet is missing, or if there is a motor failure (defective motor or a
defective motor IC drive on the main PCB).
Gobowheel 1
The gobo wheel is not located in the default position after the reset. This message will appear
if the sensor has failed or magnet is missing, or if there is a motor failure (defective motor or a
defective motor IC drive on the main PCB).
Gobowheel 2
The gobo wheel is not located in the default position after the reset. This message will appear
if the sensor has failed or magnet is missing, or if there is a motor failure (defective motor or a
defective motor IC drive on the main PCB).
Prism Rot
The prism rotation is not located in the default position after the reset. This message will appear
if the sensor has failed or magnet is missing, or if there is a motor failure (defective motor or a
defective motor IC drive on the main PCB).
Focus
The focus is not located in the default position after the reset. This message will appear if
the sensor has failed or magnet is missing, or if there is a motor failure (defective motor or a
defective motor IC drive on the main PCB).
Zoom
The zoom is not located in the default position after the reset. This message will appear if
the sensor has failed or magnet is missing, or if there is a motor failure (defective motor or a
defective motor IC drive on the main PCB).
Fan1
Fan 1 is not working correctly. This message will appear if the fan has failed or there is something
blocking the fan blades spinning.
Fan2
Fan 2 is not working correctly. This message will appear if the fan has failed or there is something
blocking the fan blades spinning.
Temp
This message will appear if the sensor has failed or the fixtures temperature is too hot.
