www.prolight.co.uk
Evora 740ZP Zoom Wash
User Manual
9
Operating instructions
Control Panel Menu:
The LCD control panel situated on the front of the fixture allows the user to access the menu system to
adjust the fixtures settings.
When the unit has been powered on the display will show
“Software Update”
followed by
“eLumen8
Evora 740ZP”
and then
“Please Wait...”
followed by
“Motor Reset Please Wait...”
. The fixture will then
return to its home screen.
Pressing the
“MENU”
button once will take the user to the fixtures main menu. Using the
“UP”
and
“DOWN”
buttons you can then navigate between the different options in the main menu. Pressing the
“ENTER”
button on one of these options allows you to access the sub menu where you can use the
“LEFT”
and
“RIGHT”
buttons to select option/value required. Once the option/value has been selected
press the
“ENTER”
button once more to confirm the setting.
To exit out of any of the above options, press and hold the
“MENU”
button.
The LCD control panel can be used via the internal battery. To access this press and hold the
“MENU”
button for 5 seconds until the fixtures home screen is displayed. The LCD display will
automatically shut off after 20 seconds of inactivity.
Error Codes:
When the unit is powered on the unit will automatically perform a motor reset. If there is a problem with
any of the motors the display will flash and display
“Error:”
along with a list of motor errors on the LCD
control panel. Please power the unit off and on to reset the motors again.
(The full list of errors codes can be found on the next page).
MENU
UP
LEFT
ENTER
RIGHT
DOWN
USB
DRIVE
WIRELESS
INDICATOR
Evora 740ZP
Zoom Wash
Error Code
Description
Pan
The movement is not located in the default position after the reset. This message will appear if the
sensor has failed or magnet is missing, or if there is a motor failure (defective motor or a defective
motor IC drive on the main PCB). This error may also be displayed if the yoke was blocked during a
reset function.
Tilt
Zoom
The movement is not located in the default position after the reset. This message will appear if the
sensor has failed or magnet is missing, or if there is a motor failure (defective motor or a defective
motor IC drive on the main PCB).
Temp
This message will appear if the sensor or fan has failed or the fixtures temperature is too hot.
Fan
