www.prolight.co.uk
Kudos 60 Beam
User Manual
6
Operating instructions
Control Panel Menu:
The LCD control panel situated on the front of the fixture allows the user to access the menu system to
adjust the fixtures settings.
When the unit has been powered on it will show
“Software Update Please Wait...”
followed by
“Motor
Reset Please Wait...”
and
“Elumen8 Kudos 60”
. The fixture will then return to its home screen.
Pressing the
“MENU”
button once will take the user to the fixtures main menu. Using the
“UP”
and
“DOWN”
buttons you can then navigate between the different modes in the main menu. Pressing the
“ENTER”
button on one of these modes allows you to access the sub menu where you can use the
“LEFT”
and
“RIGHT”
buttons to select the sub mode you require. When you have selected the option/
value you wish to adjust press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to select the
option/value required. Once the option/value has been selected press the
“ENTER”
button once more
to confirm the setting.
To exit out of any of the above options, press the
“MENU”
button.
The LCD control panel can be used via the internal battery. To access this press and hold the
“DISPLAY BACKUP”
button for 5 seconds until the fixtures home screen is displayed. The LCD
display will automatically shut off after 20 seconds of inactivity.
Error Codes:
When the unit is powered on the unit will automatically perform a motor reset. If there is a problem with
one or more of the motors an error code will flash on the LCD control panel.
TILT Er
- This error code will display if the Tilt Movement is not located in the home position after the
reset. This error code will be displayed if there is an error on the tilt initialisation.
PAN Er
- This error code will display if the Pan Movement is not located in the home position after the
reset. This error code will be displayed if there is an error on the pan initialisation.
MENU
UP
Kudos 60 Beam
LEFT
ENTER
RIGHT
DOWN
DISPLAY BACKUP
