Eltako – The System in the Building – Operating manual for Series 14 RS485 bus DIN rail mounted devices
11
Various clearing operations
Clearing memory content (taught-in sensors):
a) Clear all taught-in sensors: The teach-in memory is empty on delivery from the factory. If you are unsure whether something
was already taught-in, clear the memory content completely. Set the middle rotary switch to CLR (to position ALL for FSR14
actuators). The LED flashes nervously. Within the next 10 seconds, turn the upper rotary switch three times to right stop (turn
clockwise) and away again. The LED stops flickering and goes out after 2 seconds. All taught-in sensors are cleared.
b) Clear single taught-in sensors: Same as for teach-in except you turn only the middle rotary switch to CLR instead of LRN and
then operate the sensor. The LED previously flashing nervously goes out.
Resetting device configuration to factory settings:
Device confirmation means convenience settings which can be set especially using the PCT14 software. Turn the middle rotary
switch to CLR resp. ALL. The LED flashes nervously. Within the next 10 seconds, turn the upper rotary switch three times to left stop
(turn anticlockwise) and away again. The LED stops flickering and goes out after 5 seconds. The factory settings are restored.
Taught-in sensors are not cleared.
Resetting device configuration to factory settings and clearing device address:
Turn the middle rotary switch to CLR resp. ALL. The LED flashes nervously. Within the next 10 seconds, turn the upper rotary switch
six times to left stop (turn anticlockwise) and away again. The LED stops flickering and goes out after 5 seconds. The confirmation
is reset to the factory settings and the device address is cleared.
Clear device address: FMSR14, FSU14 and F3Z14D
Press MODE and then press SET to search for GA in the display. Now press SET to switch between the device address and 000.
When you press MODE to confirm 000, the device address is cleared. The display returns to the standard view.
Clear device address: FWG14MS
Turn the rotary switch 8 times to right stop (turn clockwise) and back again within 10 seconds. The red LED lights up for 10 seconds
and then goes out. The device address is cleared.
Clear device address: DSZ14DRS, DSZ14WDRS
Press briefly the SELECT pushbutton. The background lighting switches on. When you press the SELECT pushbutton again for lon-
ger than 3 seconds, the device address appears in the display. Then press and hold down the SELECT pushbutton for at least 5 se-
conds. The device address is set to zero.
Clear all entered IDs (filters, feedbacks): FGW14, FTS14TG and FGSM14
Turn the rotary switch 5 times to right stop (turn clockwise) and back again within 10 seconds. The LED lights up for 10 seconds
and then goes out. All IDs (filters and feedbacks) are cleared.
Clear device address and IDs: FGW14, FSDG14, FTS14TG and FGSM14
Turn the rotary switch 8 times to right stop (turn clockwise) and back again within 10 seconds. The LED lights up for 10 seconds
and then goes out. In addition all IDs (filters) are cleared in the FGW14.
In addition all IDs (feedbacks) are cleared in the FTS14TG and FGSM14.
5. Various clearing procedures
