28
KNX Interface for WS1000
• Status: 15.04.2016 • Errors excepted. Subject to technical changes.
Weather data is received from the bus
In "General Settings", the option selected is:
Set the monitoring of the wind and rain objects:
If the
KNX Interface
does not receive any wind measured value or the precipitation
status, a wind alarm or rain alarm is triggered to the controller. Drives with appropriate
automatic settings for wind or rain protection then move to the safe position.
No date / time
(
KNX Interface
is not receiving any time information from the bus
after start-up/reset):
•
In the display unit of the
KNX Interface
, the message "Please set the time" is
displayed instead of the weather animation.
No weather data
(
KNX Interface
is not receiving any weather data from the bus
after start-up/reset):
•
In the display unit of the
KNX Interface
, the message "No link to the weather
station" is displayed instead of the weather animation.
•
There is no automatic control active and the wind and rain alarms are
cautiously active, i.e. drives with the appropriate settings for wind and rain
protection move to the safe position.
•
The normal automatic mode of operation is restored only if all the weather data
has been received (brightness value, wind value, precipitation status and value
of outdoor temperature).
Brightness measurement value
• do not transmit
• transmit periodically
• transmit on change
• transmit on change and periodically
On change of
(only if "on change" is selected)
2% • 5% • 10% • 25% • 50%
Transmit cycle
(only if "periodically" is selected)
5 s • 10 s • 30 s • 1 min • … • 2 h
Weather data
receive from bus
Use monitoring of wind and rain objects
No • Yes
Monitoring period for wind object
5 s • 10 s • 30 s • 1 min • … • 2 h
Monitoring period for rain object
5 s • 10 s • 30 s • 1 min • … • 2 h
