5
Installation and commissioning
KNX Interface for WS1000
• Status: 15.04.2016 • Technical changes reserved. Errors reserved.
2.2.1. Fitting the interface to the board of WS1000
2.2.2. Connection
The
KNX Interface for WS1000
is plugged on the connection board of the WS1000
Color or WS1000 Style. There are 2 blocks with 6 pins each for this purpose (no. 2’ and
3’). Place the interface on the pins and push it down.
Connect the KNX bus cable to the bus connector (red/black) and plug the connector to
the slot of the WS1000 board (no. 1’).
Before closing the housing of the control again, set up the bus connection with the pro-
gramming button (no. 4). The KNX interface is displayed in the starting sequence of the
control (KNX interface found).
1‘ Slot KNX te/-
2‘/3‘Pins for connection of inter-
face
1
KNX terminal plug +/-
2/3 Plug sockets
4
Programming button for
setting up the device
5
Programming LED
