13
Setting parameters
Temperature Sensor KNX T-AP
• Version: 27.01.2020 • Errors excepted. Subject to technical changes.
The behaviour of the switching output on release is dependent on the value of the pa-
rameter "Switching output sends" (see "Switching output")
6.5.
Temperature PI control
Activate the control if you want to use it.
General control
Define the
type of control
. Heating and/or cooling may be controlled in two levels.
Then configure a temperature control
block
using the blocking object.
Blocking object value before first Call
0 • 1
Switching output behaviour
On blocking
• Do not send message
• send 0
• send 1
On release
(with 2 seconds release delay)
[Dependent on the "Switching output
sends" setting]
Switching output sends on change
• Do not send message
• Send switching output status
Switching output sends on change to 1
• Do not send message
• if switching output = 1
send 1
Switching output sends on change to 0
• Do not send message
• if switching output = 0
send 0
Switching output sends on change and
periodically
Send switching output status
Switching output sends on change to 1 and
periodically
if switching output = 1
send 1
Switching output sends on change to 0 and
periodically
if switching output = 0
send 0
Use control
No • Yes
Type of control
• Single level heating
• Dual-level heating
• Single-level cooling
• Dual-level cooling
• Single-level h single-level cooling
• Dual-level h single-level cooling
• Dual-level h dual-level cooling
Behaviour of the blocking object with value
• 1 = Blocking regulation |
0 = Releasing regulation
• 0 = Blocking regulation |
1 = Releasing regulation
