![background image](http://html1.mh-extra.com/html/elsner-elektronik/60121/60121_installation-and-operation-manual_2396633080.webp)
79
Installation
Control System WS1 Color / WS1000 Color
• Version: 14.12.2016 • Technical changes and errors excepted.
Rear view
Installation
First install the junction box. Seal the inlet tubes in order to prevent drafts.
Connect the power /- to the connector terminals provided for this purpose on
the sensor board. Then screw the board/base plate onto the socket. Ensure that the
front side with the writing „TOP“ is directing out of the wall and that the arrows point
towards the top.
Position the frame of the switching programme. Insert the housing of the sensor firmly
onto the base plate using the catches, so that the housing and frame are fixed together.
4.3.2. Notes on mounting and commissioning
Never expose the device to water (e.g. rain) or dust. This can damage the electronics.
You must not exceed a relative humidity of 95%. Avoid condensation.
4.3.3. Establish radio connection with WGTH-UP
1. Bring the control unit into learning readiness mode (note chapter
Learn wireless
connection
in the manual).
2. Press the programming button at the WGTH-UP sensor
Fig. 18
1
Connection for power supply
7…30 V DC (+/-)
1
The programming button is situated behind the
right lower opening of the housing.
Use e. g. a paper-clip or a wire to press the but-
ton.
Summary of Contents for 60121
Page 7: ...6 Clarification of signs ...