![background image](http://html1.mh-extra.com/html/elsner-elektronik/60121/60121_installation-and-operation-manual_2396633061.webp)
60
Automatic settings
Control System WS1 Color / WS1000 Color
• Version: 14.12.2016 • Technical changes and errors excepted.
First select the alarm output that you want to set.
Select the alarm source which should activate the alarm output relay. More than one
source can also be selected:
•
Smoke detector (multifunctional output)
•
Motion detector (multifunctional output)
•
Rain alarm from weather station
•
Wind alarm. Adjust the values for wind speed and duration of the exceedance.
A triggered wind alarm will be maintained for 5 minutes. If during these 5
minutes the saved value is exceeded again, the holding time begins again
•
Frost alarm of the control
Confirm your setting with the
OK
button.
3.1.13.Setting motion detectors
If a motion-detector is connected, a period of time during which the control system will
react to the movements detected can be set (severe alarm). If an alarm is triggered
within this time, all windows will close for around 5 minutes. The display (starting po-
sition with weather data display) reads "Motion-detector alarm." After 5 minutes with-
out a new alarm signal, normal automatic operation will be resumed.
Even manually opened windows will be closed when there is a
motion-detector alarm!
If a multifunctional output is configured as an alarm output, it closes for the duration
of the alarm signal.
3.2. Set up alarm
Lights can also be switched on when the alarm is active.
3.2. Automatic light settings
The motion-detector settings can be accessed by pressing the buttons:
First select the motion detector that you want to set. Press
Select
to select the time
during which the motion detector alarm should be active. Activate one or more periods
on the list. The operating times can be individually customised (see below).
Confirm your setting with the
OK
button.
To change any of the time periods, press
Timer
.
3.3. Set timer
3.2.
Adjust general automatic settings
The settings applied here are used for all drives and devices, or are applicable to the
drive types defined in the relevant chapter (e.g. for all shades).
Automatic
Settings
Motion Detector
System
Summary of Contents for 60121
Page 7: ...6 Clarification of signs ...