Device description
elrest
Automationssysteme GmbH
e
VISIO PTE715_Windows.EN
Page: 17
2.1.6.2
Position of the terminal blocks
The mounting plate for mounting the panel must not be more than 6 mm thick.
Torque:
The screw is tightened by hand for the correct torque.
That the seal is evenly fitting, the following value for the tightening torque has to be applied:
PTE715
0,2 Nm
Tighten the screws just so that the seal between the front and the mounting cutout is
completely compressed and sealed. Too strong and / or uneven tightening of the screws can
damage the device!
Only if all clamping bolts are used, the tightness IP54 (front) can be achieved.
Overturning the screws can destroy the block.
Figure 3 : Attaching of the brackets on the mounting plate
2.1.7
Disassembly
Loosen the fastening screw. Thread should complete with plastic body. The disassembly is carried out in
the reverse order of assembly.
Terminal blocks
Put in
Snap