SP205EQ
DUAL 1x5 VIDEO & AUDIO DISTRIBUTION AMPLIFIER
WITH EQUALIZATION & LEVEL CONTROL
ELPRO Video Labs s.r.l.
Str.da della Pronda, 45/B 10142 TORINO - ITALY
Tel.+39 0117701583 – Fax +39 011703751
7
WARNING
Output terminal "a" is in phase
with input terminal "a".
Output terminal "b"
is in counter phase in relation to "a"
WARNING
If the destination is unbalanced, connect
terminal "a" and GND.
Leave terminal "b" free or use it
for another destination
3.2 Audio
part
3.2.1 Overview
Regardless of the type of configuration used, pay attention to the warnings
below.
3.2.2 Dual 1x5 distributor
To use the unit as dual 1x5 distributor with two sources, proceed as follows:
a) Make sure that all the units to be installed are OFF.
b) Set the switch on the front panel to the “DUAL 1x5” position
remembering that this setting acts not only on the video but also on the
audio.
c) Connect the first audio source to the AUDIO IN1 connectors and the
second source to the AUDIO IN2 connectors.
WARNING
The ground terminal (GND) is
common to the L and R channels
WARNING
If the incoming signal is
unbalanced, connect the hot pin to
terminal "a" and the cold pin to
terminal "b".
Then, jumper "b" with GND
WARNING
The SP205EQ input is at high
impedance.
The input of several SP205EQ can
be set in parallel
