Chapter Three
Operation
Page 25
© April 2007
f)
Set Boot Netmask to the same settings as the computer you have the Ethernet cable
connected to. This may be performed with the command: bnm <Type the netmask>
g)
Set Boot Gateway to the same settings as the computer you have the Ethernet cable
connected to. This may be performed with the command: bgw <Type the gateway IP
address>
h)
Choose an IP address for the 805U-E being upgraded. This IP address must be on the
same network as the computer you have connected the Ethernet cable to. This may be
performed with the command: bip <Type the IP address>
i)
Switch dip-switch on 805U-E to RUN position.
j)
Type the command reset, or cycle power to the unit. The 805UE will reset and start with
the network settings you have entered.
k)
Open Internet Explorer and ensure that settings will allow you to connect to the IP
address selected. If the PC uses a proxy server, ensure that Internet Explorer will bypass
the Proxy Server for local addresses. This option may be modified by opening Tools ->
Internet Options -> Connections Tab -> LAN Settings->Proxy Server -> bypass proxy
for local addresses.
l)
Enter the webpage http://xxx.xxx.xxx.xxx/ where xxx.xxx.xxx.xxx is the IP address selected
for the module. A welcome webpage should be displayed as illustrated.
m)
Clicking on any of the menu items, and entering the username “user” and password
“user” may open Configuration and Diagnostics. If the password has previously been
configured other than the default password, then enter this instead.
