Elnur
powered by Gabarrón | RXE PLUS | Installation Guide
8
OPEN WINDOW DETECTION
With open window detection activated, the heating
element will be disconnected automatically when a
sharp decrease in temperature in the room is detected
avoiding energy wastage. After this period of time,
the radiator returns to the prior operation mode.
When Open Window Detection is working, the word
Open will be displayed alternating with the status
of the current mode.
Note: To activate the open window detection please
refer to ADVANCED FUNCTION ACTIVATION section.
ADAPTIVE START CONTROL
RFE Plus electronic control analyses the heating
requirements of the room where the radiator is installed
using this information to turn on the heating element in
advance in order to reach the set point temperature at
the desired time.
When Adaptive Start Control is working, the word AdAP
will be displayed alternating with the status of the
current mode.
Note
: To activate the adaptive start control please refer
to ADVANCED FUNCTION ACTIVATION section.
ADVANCED FUNCTION ACTIVATION
Advanced functions Open Windows Detection and
Adaptive Start Control are disabled by default.
To enable / disable these functions, the following
steps must be followed:
Move the selector to
0
position, the display will be Off.
Press the
key and at the same time turn the selector
to
P
position maintaining the
key at least five
seconds.
The display will show
OPEN
alternating with the status
of the function (On or OFF). Use the navigation keys + or
– to enable / disable Open Windows Detection function.
Confirm the new value for the function by pressing the
PRG
key. The next function (AdAP) is shown alternating
with its status (On or OFF). Use the navigation keys +
or – to enable / disable Adaptive Start Control function.
Confirm the new value for the function by pressing the
PRG
key.
The heater reset establishes the factory configuration
of the heater removing the programming, establishing
the daily programming and disabling the advanced
functions. To reset the unit, hold the
PRG
key for 4
seconds, the display will show
InIC
to indicate the
heater has been reset.
6: CLEANING AND MAINTENANCE
The radiators do not require any special maintenance
providing thermal comfort during large periods.
Clean dust with a dry, soft cloth only when the unit
is disconnected and cold.
Do not use solvents or abrasive products for cleaning.
This thermal radiator has been manufactured under
an assured quality system using environment friendly
processes.
Please take the heaters to a clean point once their
useful life is finished, in order to recycle their materials
in the right way.
4: ADVANCED FUNCTION
5: UNIT RESET
