Elnur
powered by Gabarrón | RFE PLUS | Installation Guide
7
It is possible to allocate different programmes to
different days of the week. To do this, the controller
has to be changed from 24hr mode (factory default)
to 24hr/7days mode as follows:
Move the selector to
0
position, the display will be
Off. Press the key and at the same time turn the
selector to
P
position maintaining hold of the key
for five seconds. The display will show
P-SE
which
means that weekly mode has been set.
SETTING THE DAY:
Press and hold the key until the display shows the
number of the day. Set the correct number, if required,
by pressing the + or – keys. Press the key again and
the values will be saved.
To check a programme or to make a new one press
PRG
key. The display will show
day1 .
Press the
PRG
key again and the display will show
00:00
intermittently. Follow the steps from the DAILY
PROGRAMMES section until the display shows
day1
.
again. Repeat this process with the 7 days of the week.
When the display shows
day7
the weekly program
will be stored by pr key.
If the display shows day1 then pressing and holding
the + key will copy the day 1 program to day 2 and
so on.
It is possible to allocate any of the three temperature
levels to all of the intervals on any of the days by
holding the relevant (temperature mode) key until an
audible signal is heard.
To turn back the controller from 24hr/7days to a single
24hr period press the
PRG
key for six seconds. This will
restore the factory default settings.
Press and hold the key until the following is shown
on the display The heater will still function
internally. To unlock the keyboard press and hold the
key.
SUN MANUAL OVERRIDE
In programming mode, the heater will maintain the
sun temperature set point and will ignore the pre-set
programme until the next change in the programming
temperature level.
Hold the SUN key pressed in programming mode to
set the sun manual override. Both SUN and MOON
indicators will be lit to confirm this.
This function could be useful when SUN temperature is
required and we do not want to modify the program.
By pressing the SUN key for 4 seconds with Sun Manual
Override activated, the function will be removed and
the heater will follow the programme again.
WEEKLY PROGRAMMES
KEYBOARD LOCK
