3
3.- USING THE THERMAL RADIATOR
ELECTRONICS MODELS RX-P
Operation in electronic models is controlled by means of two rotary knobs.
It is possible to regulate the temperature level with accuracy by means of
the
temperature selector
. The heating indicator will be lit when the
heater is consuming energy. When this dial is set in * position the heater is
in frost protection mode, at this stage if the room temperature drops below
3ºC the heater will connect itself automatically.
There are three selectable positions with the
mode selector
dial:
0
: The heater is switched off permanently. No frost protection mode
here.
: SUN mode on, the heater maintains the set temperature with the
temperature selector dial.
: Moon mode on, the heater maintains a temperature 3ºC lower than
the one set with the temperature selector dial.
- The studs and screws are in the accessories bag.
- Hung the unit on the hooks of the brackets.
- By turning the screw the metallic square will go downwards, retaining the heater. Repeat this on the other bracket.
Use the heater as a template
and mark the fixing points on
the wall using a pencil through
the two fixing holes in the
square brackets.
Position and fix the brackets at the correct distance from the floor
and hang the unit on the hooks of the brackets. And mark the wall.
Use the polystyrene packaging to level the heater and protect the
floor.
SUN mode
indicator
modo SOL
MOON mode
indicator
Heating
indicator
De consumo
Temperature
selector
Mode
selector
