Elnur
powered by Gabarrón | ECOMBI SSH | User Guide
15
ECOSSH TROUBLESHOOTING, ERROR CODES AND WHAT TO DO:
Error
E
rror Reason
Resolution
ECOSSH Does not heat
1. Check everything is connected
and the switch is on at the back
right hand side.
2. Make sure heater is not in frost mode
3. Ensure nothing is covering the
inlets or outlets.
4. If all above checked call
Technical line
ECOSSH does not reach set up
temperature
1. Make sure that the adequate
temperature is set up.
2. Check that the balancing
element is not turned off in UP08
Keyboard does not respond
If the lock symbol is displayed, the
keyboard is locked. Hold “+” and “-”
buttons simultaneously for 3 seconds
to unlock the keyboard. (See Keyboard
Lock Section).
ECOMBI SSH does not communicate
with the G Control Hub
Check the unit is associated. The “Link”
symbol must be shown on the display
LCD. For distances greater than 30
metres and 2-3 walls, associate first
the closest unit. Each unit can work as
signal extender.
If the “Link” symbol is flashing check
G-control connection to the network.
Err1
90°C Registered at the main PCB
Call fitter and get him to check that the
microtherm panel is fitted correctly. If
still not fixed please get fitter to call us.
Err2
180°C Registered in the Core
Call fitter and get him to check that the
microtherm panel is fitted correctly. If
still not fixed check then possible safety
cut out has been triggered. If still not
working then please get fitter to call us.
SC – OC
Core Sensor Error
Please call our technical line
SA - OA
Room Sensor Error
Please call our technical line
