32
MODEL:eXperience 660
Setscrew (B)
Setscrew (A)
Setscrew (A)
Zigzag width motor
Setscrew (B)
REPLACING THE ZIGZAG WIDTH MOTOR
REPLACING THE ZIGZAG WIDTH MOTOR
TO REMOVE:
1. Remove the printed circuit board "A" (see page 8).
2. Remove the two setscrews (A).
3. Remove the two setscrews (B) and remove the zigzag width motor.
TO INSTALL:
4. To install the zigzag width motor, follow the above procedure in reverse.
NOTE:
1. The setscrews (A) should be tightened at 5-7 kg of torque.
2. Check to ensure that the upper shaft sensor mounted on the zigzag width motor does not interfere
with the upper shaft shield plate.
3. Adjust the needle drop position (see page 11).
