9
0.2 mm
or more
0.2 mm
or more
(A)
(B)
A = B
MECHANICAL ADJUSTMENT
NEEDLE DROP POSITION
Needle plate hole
Select the zigzag stitch .
Set the stitch width to “5.0”.
The clearance between the needle drop position and the edge of needle should be 0.2 mm or more for both
sides.
If not, make the adjustment as follows:
1. Turn the power switch on.
2. Remove the face cover (Refer to page 4).
3. Set the stitch width to “5.0”.
4. Make the following adjustments if the clearance between the needle drop position and the adge of the needle
are even for both sides.
* Turn the setscrew clockwise (in the direction of A) if the clearance on the right side of the needle plate hole is
smaller than 0.2 mm.
* Turn the setscrew counter clockwise (in the direction of B) if the clearance on the left side of the needle plate
hole is smaller than 0.2 mm.
NOTE:
Check the hook timing after this adjustment.
Setscrew
