27
Adjusting X and Y Sensors (Instant Adjustment)
To adjust X and Y sensor (without removing the base unit):
1 Remove the base cover.
2 Remove the presser foot holder and attach the
Embroidery foop (A) .
3 Turn the Power “ON” and select the Embroidery
Mode, then press pattern No.1.
4 Turn the handwheel by hand to check that the
Needle drops into the Starting position on
the Template .
5 Turn the Power “OFF”.
6 If the needle position shifts in Y direction, loosen Screw
(A) and move the Y sensor fixing plate to
adjust the needle drop position.
7 If the needle position shifts in X direction, loosen Screw
“B” through the sheet cover fixing plate hole and
adjust the X shield plate possition .
8 Turn the Power “ON” and select pattern No.1 on the
Embroidery Mode, then check the Start position .
9 Return the carriage to the home position and turn the
Power “OFF”.
10. Remove the Template and the Embroidery hoop
, then reattach the base cover.
Embroidery hoop (A)
Template
Marks
Needle
Start position
Screw (B)
X-shield plate
Sheet cover fixing hole
Screw (A)
Y-Sensor fixing plate
10
8
6
7
3
2
1
4
5
6
9
1
5
4
2
9
10
6
7
5
2
1
1
2
3
4
5
6
7
8
9
10
