17
Replacing Threader Plate and Adjustment
If the hook on the threader plate is damaged, replace it by following the instructions below.
Replacing threader plate
1. Remove the presser foot.
2. Push down the Threader supporter plate (A) to
remove from the Pin (B) . (Drawing 1.)
3. To attach the threader supporter plate, match the groove
of the Threader supporter with the pin , and
then push it up to insert.
Threader supporter (A)
Pin (B)
Hook
Adjusting threader plate position
1 When the hook is slightly touching the nedle eye,
loosen Screw (C) and adjust the Threader plate
as shown.
If the hook position is too high or too low
1 Remove the face cover.
2 If the hook is too high, loosen the screw (D) and
lower the Setting position plate .
If the hook is too low, loosen Screw (D) to
slide up the Setting position plate .
Screw (C)
Threader plate
Screw (D)
Setting position plate
Needle bar
1
2
3
2
1
1
2
3
(X) View
(X)
DRAWING 1
DRAWING 2
DRAWING 3
1
2
3
4
1
2
3
4
5
4
3
2
1
4
3
5
1
2
