ELNA 6200 -, Service Manual

Page: 20 / 37

19
▲
▲
Ｃ Ｃ
Ｃ Ｃ Ｃ
Ｄ Ｄ
Ｄ Ｄ Ｄ
THE WINDOW DISPLAYS "1".
36±3mm
1. SET UP THE MACHINE IN ADJUSTING MODE (SEE BELOW).
2. SET THE FEED BALANCING DIAL AT THE STANDARD SETTING MARK ( ).
3. CHECK THE SEWING RESULTS (THE STANDARD FIGURE LENGTH OF FIVE PIECES OF FIGURE 8 IS
33–39 MM).
4. REMOVE THE 2 SETSCREWS. THEN REMOVE THE BASE CAP.
5. IF THE LENGTH IS LONGER THAN 39 MM, TURN THE ADJUSTING SCREW IN THE DIRECTION OF (C).
6. IF THE LENGTH IS SHORTER THAN 36 MM, TURN THE ADJUSTING SCREW IN THE DIRECTION
OF (D).
7. REATTACH THE BASE CAP AND TIGHTEN THE SETSCREWS.
WHEN A STRETCH PATTERN IS SEWN WITH THE FEED BALANCING DIAL (C) SET AT THE
STANDARD MARK ( ), THE PATTERN SHOULD BE AS INDICATED WITH THE "O".
STRETCH STITCH FEED BALANCE STRETCH STITCH FEED BALANCE
STRETCH STITCH FEED BALANCE STRETCH STITCH FEED BALANCE STRETCH STITCH FEED BALANCE
FEED BALANCING DIAL
STANDARD
SETTING MARK
TO ENTER THE ADJUSTING MODE
TURN THE POWER SWITCH ON WHILE
PRESSING THE"–" OF SITTCH WIDTH
BUTTON AND `+` OF STITCH LENGTH
BUTTON.
PRESS THE "–" OF STITCH WIDTH
BUTTON.
BASE CAP
ADJUSTING
SCREW
SETSCREW