BACK PANEL
Back panel
On the back panel there are 4 speaker
speakers.
Make sure the internal speaker(s) is connected to the
If use with internal and/or external speaker cabinets, make sure the impedance matching
is correct - Ohms law: 2x8 ohms speakers equal
equals 8 ohms.
There are also three knobs;
Presence
The Presence control is global
high mid / treble to the sound.
Reverb
A four spring AccutronicsTM
sound. Also global - affects both Channels.
Mix
Mixing control for the F/X loop. When set fully counter clock wise
loop is in parallel mode. Only some of the effects connected in
sockets are mixed in to the dry signal. The internal signal path in the amplifier is not
affected.
Turning the Mix knob more and more clock wise towards the 100% mark
F/X loop become more and more serial. When turned
serial mode.
The signal path in this mode is
Pre-amplifier > connected Effect
The whole internal signal is now going through the connected effect unit.
This might colour the sound.
The F/X loop is designed for stomp
units as well. The F/X loop is active on both Channels.
Note:
Parallel mode suits time related effects such as Reverb
and Delay. Serial mode suits real
Compressor and Equalizer
Note:
Never operate the amplifier without a conn
since this can cause severe damage to the amplifier.
back panel there are 4 speaker outputs for connecting internal and/or external
Make sure the internal speaker(s) is connected to the
8 ohm jack socket
.
If use with internal and/or external speaker cabinets, make sure the impedance matching
Ohms law: 2x8 ohms speakers equals 4 ohms and 2x16 ohms speakers
The Presence control is global - it affects both Channels. Adjusting this will add more
high mid / treble to the sound.
A four spring AccutronicsTM Reverb. Adjusting the Reverb knob will add room to the
affects both Channels.
Mixing control for the F/X loop. When set fully counter clock wise, at the 10% mark, the
. Only some of the effects connected in the Send and Return jack
sockets are mixed in to the dry signal. The internal signal path in the amplifier is not
x knob more and more clock wise towards the 100% mark will make the
F/X loop become more and more serial. When turned fully clock wise the F/X loop is in
The signal path in this mode is:
connected Effect unit > Power-amplifier.
The whole internal signal is now going through the connected effect unit.
This might colour the sound.
F/X loop is designed for stomp boxes, -10dB to -20 dB, but will operate with rack
units as well. The F/X loop is active on both Channels.
Parallel mode suits time related effects such as Reverb
and Delay. Serial mode suits real-time related effects such as
Compressor and Equalizer
Never operate the amplifier without a connected speaker
since this can cause severe damage to the amplifier.
ternal and/or external
If use with internal and/or external speaker cabinets, make sure the impedance matching
s 4 ohms and 2x16 ohms speakers
it affects both Channels. Adjusting this will add more
verb. Adjusting the Reverb knob will add room to the
, at the 10% mark, the
the Send and Return jack
sockets are mixed in to the dry signal. The internal signal path in the amplifier is not
will make the
fully clock wise the F/X loop is in
but will operate with rack
