31
movita
by elmi
ENGLISH
be checked with the help of the marks on both posts. The seat height is adjusted by loosening the
two upper release handles (fi gure 6A). After reaching the height desired the two release handles
must be tightened again. Both sides have to be at the same height.
The thoracic ring should be adjusted to the approx. armpit height. Then the seat should be ad-
justed; the right position is about 2-3 cm under the inseam.
Thoracic ring:
(fi gure 5 page 30)
the thoracic ring can be opened and closed by slightly rotating the upholstered tube.
Springs:
The two springs in the lower tubes can be exchanged if a harder or softer spring tension is neces-
sary. The springs are available in various strengths in relation to the following bodyweights. For
identifi cation the springs have different colours:
For standing-and walking support movita child I and child II:
green
= min. 10 kg
light blue = min. 15 kg
orange
= min. 20 kg (standard)
white
= min. 25 kg
For standing-and walking support movita junior, adult medium and adult large:
white
= min. 20 kg
yellow
= min. 40 kg (standard)
blue
= min. 70 kg
red
= min. 100 kg
Each package with spare springs contains labels with the correspondent min. loading capacity.
If the springs are substituted these labels have to be stuck on the outer side of the frame under the
spring coverage.
To change the springs the upper frame has to be removed.
Seat:
The seat can be slid forward and backward by loosening the big screw under the tube of the seat.
After reaching the desired position tighten the screw again. The seat angle can also be adjusted
by loosening the two hexagonal screws underneath the seat. Tilt the seat to the desired angle and
tighten the screws to secure.
Pelvis support:
The pelvis support can be tipped up or down with a hexagonal screw. After loosening the screw
the support can be tipped down. After adjustment the screw is tightened to secure.
Support handle:
The support handle is fi xed to the frame by an aluminium clamp assembly. Loosen the two hexago-
nal screws to adjust height and depth of the handle. After reaching the desired position tighten the
