Technical Support Line +44 (0)23 9269 6638 (Option 3)
PAK200544 Iss 01A Mar 2012
©2012 ELMDENE INTERNATIONAL LTD
F
AULT
F
INDING
Symptom
Fault
Action
Sounder activated in non-
alarm condition and tamper
shows at panel
Cover not closed correctly.
Check cover closed and screw secure.
Rear tamper pin not correct length
Correct rear tamper pin length.
R- not pulled up to +12V in standby
mode
Fit pull up resistor to R- at control panel.
See Fig 1, Note 1
Sounder stops after 5s
Incorrect timer link setting
Set correct timer jumper links.
Cannot SET control panel
(due to sounder tamper)
Tamper output open due to ENG input
still connected to H+
Disconnect ENG from H+ in sounder or set
control panel programmable output low.
Tamper Source (TS) not connected to H-
for single sounder or to Tamper Return
(TR) for cascaded sounders
Refer to connection diagrams for single
and cascaded sounders (Figures 1 and 2).
Total resistance of tamper circuit too
high for multiple sounder installations
Reduce number of cascaded sounders on
one tamper loop.
Cover or Rear tamper switch not closed.
Check cover and rear tamper switches fully
closed.
Ring trigger signal (R-) disconnected
(floating)
Ensure R- pulled up to above 8.5V.
Fault output open
Battery not connected
Check battery connections to terminal
block.
Battery faulty or voltage low
Replace battery.
Piezo fault
Return unit to manufacturer.
Battery charger faulty
Clicking noise from sounder
during commissioning
See Commissioning Mode table.
D
ISPOSAL OF
P
RODUCT AT
E
ND OF
L
IFE
This product falls within the scope of EU Directives 2002/96/EC Waste Electrical and Electronic Equipment
(WEEE) and 2006/66/CE (Battery). At the end of life, the product must be separated from the domestic
waste stream and disposed via an appropriate approved WEEE disposal route in accordance with all
national and local regulations.
Before disposal of the product, the SAB battery must be removed and disposed separately via an
appropriate approved battery disposal route in accordance with all national and local regulations. Package
used batteries safely for onward transport to your supplier, collection point or disposal facility.
Caution: risk of fire or explosion
if bare battery wires are allowed to touch.
See Specification for battery type information. The battery is marked with the crossed out wheelie bin
symbol, which may include lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg).
For more information see: www.recyclethis.info
9
