Elma DT173
side 13
Data output : USB data traffic
Power: one 3.6V battery, specs:14250 or 1/2AAA
Electric current : when measuring,5.5mA; when periphery power is off or stop
measuring:30uA
Battery life: About 200 hours
Operation temperature and humidity: 0°C ~40°C,
10%RH~90%RH
Storage temperature and humidity: -10°C ~+60°C,
10%RH~75%RH
Dimension
:
144.12mm x 27.33mm x 14.06mm
System requirement: Windows 2000 or Windows XP or Vista
Minimum hardware requirement
：
8M EMS memory, 2M hard disk, a free USB jack
Accessories: instruction manual, battery, windscreen, transparent cap, CD
NAME OF PARTS AND POSITIONS
1. Green LED
2. Red and yellow LED
3. Button: turn on the Datalogger
LED FLASH INDICATION
Single LED flash indication
RED LED: The input signal over the alarm range.
(2 times-high alarm, one time-low alarm)
Yellow LED: Memory full (10s/time)
Green LED: DataLogger normal working indication (10s/time)
Mixed flash:
red
→
green
→
yellow: DataLogger start to measure (indication after operation manually)
red and yellow alternately: download the data to PC Red and green LED flash
simultaneous: low battery indication (10s/time)
OPERATING INSTRUCTIONS
1. Setup the DataLogger by software before use it.
2. Under the Manual mode, press and hold the button for 2s, DataLogger start to measure, and
LED indicates the function at the same time.( see LED FLASH INDICATION for details.)
3. Under the Automatic mode, the DataLogger start to measure after setup in software
，
LED
indicate the function at the same time.( see LED FLASH INDICATION for details.)
4. During measurement, the green LED indicates the working state by flashing with the frequency
setup in the software.
5. When datalogger memory full, yellow LED will flash 10s/time.
6. During measurement, when measured value exceeds the alarm range, the red LED will flash. (
2 times-high alarm, one time-low alarm)
7. As the battery power is not sufficient, red LED will flash 10s/time for indication.
8. DataLogger data can be read time after time, the readings you are checking are the real time
measured ones.
（
1 to 129920 readings
9. Without battery, the latest 1.5 hours (the most) data will be lost. Other data can be read in
software after battery is installed.
10. When replacing the battery, turn off the meter and open the battery cover. Then, replace the
empty battery with a new 1/2AAA 3.6V battery and go for the cover.
