DGS 10
side 8
Battery replacement
1. Remove the Protective Rubber Boot by slipping it away from the bottom of the case
and sliding it along the flexible goose neck exposing the case back.
2. Remove the battery compartment cover from the bottom of the case by removing
the 2 screws.
3. Remove the battery and replace with an Alkaline MN 1604 9 volt battery (or
equivalent). Be sure to connect the negative (-) and positive (+) terminals of the
battery the correct way around in the battery connector.
4. Replace the battery cover in position by using the two screws. Take care not to
over tighten the screws or you may break the case.
5. For best results and longer life always use quality alkaline batteries MN 1604 or
equivalent.
Operation check
To verify the operation of the DGS-10 simply turn the unit on and allow it to warm up for
approximately one minute.
Expose the sensor to a gas source as previously referred to under General Description.
The tic should increase when the gas is applied. The tic will decrease when the gas is
removed. If the unit fails to respond, the sensor may need replacing or the unit may need
to be sent in for repair:
CAUTION: This unit must be sent to a factory authorised repair centre for all repairs.
Standard accessories
Your DGS-10 is supplied complete with:
• Protective Rubber Boot
• 9 volt Alkaline Battery
• Instruction Manual
TG: 29062011, ver 1.
