Elm Plus EPL1020, User Instruction, Page: 21 / 24

User Instruction
18
7. Once the appliance is lit, flame height can be changed by adjusting the burner control
knob between the "High" and "Low"
8. Always check burner flames periodically to ensure proper operation. Flames should be
mostly yellow with some blue for best performance. (See diagram)
9. Inspect the burner everytimes before use, if evident that the burner is damaged, or the
burner can not lighting, pls contact the manufactory to get the appliance to replace it.
1. Connect propane (LP) cylinder (see above pages).
2. Before lighting, move the glass beads with a small shovel
to allow access to the burner.
WARNING:
Glass beads can become very hot.
DO NOT touch unless they are completely
cooled.
3. Locate the burner control knob and make
sure it is in the "OFF" position.
4. Wearing heat resistant gloves, position a long lit match or lit long neck lighter close to the
burner ports. DO NOT lean over the burner while lighting.
5. Push and turn burner control knob to the "LOW" position. The burner should lit within 15
seconds.
6. If ignition does occur within few seconds, turn the burner control knob to "OFF", wait 5
minutes for gas to clear and repeat the lighting
procedure. If burner still will not light, refer to the Troubleshooting
Section.
7. Flame height can be changed by adjusting the burner control knob between the "LOW"
and "HIGH" positions.
8. Always check burner flames periodically to ensure proper
operation. Flames should be mostly yellow with some blue for best performance.
Improper lighting procedure will cause injury or
damage. If the burner does not ignite with the burner control
valve open, gas will continue to flow out of the burner and
could accidentally ignite causing injury or property damage.
USING A LONG MATCH OR LIGHTER
10 In
25 cm
1 In
2.5 cm
IGNITER-PUSH
OFF
HIGH
LOW