4
PTTC Series Cutter Motor
Safety Instructions (cont.)
1. Maintain balanced body position and secure footing.
2. Repetitive work motions, awkward positions and exposure to vibration can be harmful
to hands and arms. If numbness, tingling, pain or whitening of skin occurs, stop using
this tool and consult a physician.
3. Avoid inhaling dust or debris from work process which can be harmful to your health.
4. Proceed with care in unfamiliar surroundings. Hidden hazards may exist, such as electric
or other utility lines.
5. This tool is not intended for use in an explosive atmosphere and is not insulated for contact with
electrical power sources.
6. Do not operate this tool if it is wet and/or in humid ambient conditions.
7. When operating this tool always hold with both hands and maintain a safe distance.
8. Do not operate this tool without the torque reaction Handle.
9. Always use sharp cutting accessories to prevent tool lock up.
10. Always consider the torque reaction of this tool, especially when the tool’s cutting accessory
locks.
Protection
Wrong handling can result in injury to the operator and/or damage to the tool. The tool must be used
with sharp cutting accessories to improve cutting capacity and protect the tool. Locking the tool may
cause overload, the gear box is equipped with a clutch for locking protection.
For additional safety information consult:
• U.S. Department of Labor, (O.S.H.A.); Council of the European Communities and or local
codes.
• Your employer union and/or trade association.
GROUND ALL TOOLS!
This tool should always be plugged into a three hole electrical receptacle.
If an adapters used to accommodate a two hole receptacle, the grounding ear must be attached
to a known ground. Never remove the third prong.
Inspect power cord and plug each time prior to using the tool. Any torn or frayed cord must
be immediately replace by a qualified electrical service tool technician.
11. Do not abuse the power cord. Never carry the tool by the cord or yank it to disconnect
from the receptacle to disconnect.
12. Always disconnect the tool from the power source before making any adjustments to tool
accessories connected to the tool.
13. Prevent body contact with grounded surfaces such as pipes and other structures.
