3. Installation Preparation.
page 3
4. Hanging Bracket Installation.
This fan can also be mounted with a
downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by purchasing a
longer downrod (0.5in./1.27cm diameter).
After
installing hanging bracket,
c
ontinue to Section 5 on
page 4 for those instructions.
This fan can also be
mounted using
flushmount
installation
only
on a
regular (no-slope) ceiling.
After installing hanging
bracket, continue to Section 6 on page 5 for those
instructions.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
Vaulted ceiling
angle is not to
exceed 25 degrees.
downrod
installation
flushmount
installation
blade edge
(76cm)
30
inches
hanging bracket
spring washers
outlet box screws
flat washers
7 feet
(2.13m)
10f
t.
- 12f
t.
10ft. - 12ft.
(3.05m - 3.66m)
(3.05m - 3.66m)
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 144 square
feet (13.4 square meters).
Turn off circuit breakers to current fixture from breaker panel
and be sure operating light switch is turned to the OFF position.
WARNING:
Failure to disconnect power supply prior to installation
may result in serious injury.
Remove existing fixture.
WARNING:
When using an existing outlet box, be sure the outlet
box is securely attached to the building structure and can support
the full weight of the fan. Ensure outlet box is clearly marked
"Suitable for Fan Support." If not, it must be replaced with an
approved outlet box. Failure to do so can result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly and that a
ground wire (green or bare) is present.
Locate screws in slotted holes of canopy and partially loosen
these screws. Remove the other 2 screws (along with star
washers)--
save for later use
. Twist canopy to remove hanging
bracket from canopy.
Install hanging bracket to outlet box using original screws,
spring washers and flat washers provided with new or original
outlet box.* If installing on a vaulted ceiling, face opening of
hanging bracket towards high point of ceiling. Arrange electrical
wiring around the back of the hanging bracket and away from
the bracket opening.
*Note
: It is very important that you use the proper hardware
when installing the hanging bracket as this will support the fan.
