Ellies FBIC3000VA/24V, User Manual

Page: 13 / 20

12
The voltage parameter are at 250C, 24VDC system, and twice in 48VDC system.
NOTE: When Output source priority is Battery and the battery voltage lower than the Low Voltage Disconnect
Voltage(LVD
adjustable), the system will switch utility to supply power for load.
2) Advanced interface for engineers
Operation:
Step1: Press the + button and hold on 5s under the real-time interface.
Step2: Press the button and hold on 5s under the setting parameter interface.
Step3: Press the button to enter the parameter.
Step4: Press the button to exit the setting interface.
Setting
：
Item LCD Instruction Default Range
9 BCT Boost Charging Time 30M 30M/60M/120M/180M
10 BCV Boost Charging Voltage
AGM
：
28.8 VDC
GEL
：
28.4 VDC
FLD
：
29.2 VDC
USER
：
28.8VDC
VDC
VDC
VDC
VDC
User 25.0
〜
29.6
Step size 0.2
11 BVR Boost Voltage Reconnect
26.4VDC
User: 25.0
〜
28.0
Step size 0.2
12 FCV Float Charging Voltage
27.6 VDC
User: 26.0
〜
28.0VDC
Step size 0.2VDC
13 OVR Over Voltage Reconnect Voltage
30.0 VDC
User: 29.0
〜
31.0VDC
Step size 0.2VDC
14 OVD Over Voltage Disconnect Voltage
32.0 VDC
User: 31.0
〜
32.2VDC
Step size 0.2VDC
15 AOF
Auxiliary module OFF voltage
Auxiliary module ON voltage
28.0VDC
User: 24.0
〜
29.6VDC
Step size 0.2VDC
16 AON 24.0 VDC
17 DON 22.2 VDC
User: 21.6
〜
24.0VDC
Step size 0.2VDC
18 DOF Dry connect OFF voltage
Dry connect ON voltage
24.0 VDC
User: 24.0
〜
26.5VDC
Step size 0.2VDC
19 MCC Max. charging current 60.0A 15.0
〜
60.0A
20 PSM Power saving mode OFF ON /OFF
21 CFA Clear fault OFF ON /OFF
22 QCL Clear the accumulated energy OFF ON /OFF
23 VER Software version U-1.0 —
The voltage parameter are at 250C 24VDC system (twice in 48VDC system ).
For the inverter/charger of different power, the current setting range is not the same, see Technical Parameters
for details.
NOTE
15/16
：
Stop/restore auxiliary module charging voltage
Only when the charging mode is Solar priority or Utility priority will the auxiliary module charging voltage be
effective.
20: Power saving mode
When the switch is on “Saving” side, the inverter will enter into the Saving Mode. It will shut off the output if the loads
value is less the 70W. Then restart and detect the power of the load again after 10s. If the load is more than 70W, the
inverter will turn on the output. Otherwise it will shut off output. It cycles like this. So please don’t use the saving mode
if the load is smaller then 70W.
21: Clear the faults
In occurrence of short circuit or overload caused to AC output, the fault can be cleared out.