ellere EL100R, Owner'S Manual

Page: 15 / 27

15
Note - Before you start, make sure to read the previous page
explaining how to remove the front glass screen.
Note - The fire must be installed in its final location before the
crystals and logs are installed.
1. Cut open the crystals bag(s) and disperse all the crys-
tals evenly on the fuel
- bed tray in a side to side motion.
2. Next, cut open the charcoal bag and using the same
side
- to - side technique, disperse most of the charcoal
on top of the crystals. Save some for later.
3. Place the logs on the surface of the crystals, leaving a
gap underneath so the flame effect is visible below
each log. To enhance the bed further, disperse the re-
mainder of the charcoal in and around each log.
4. If you need to, adjust your log positioning, refit the
glass screen, then sit back and relax.
Installation - Fuel - bed set - up