(1.3) Installation and Operation
1. This Controller should be mounted in a suitable enclosure with a minimum IP 54 rating or
suitable rating for the environment and should be:
a) Vertically mounted and free from vibration
b) Not exposed and free from dust and debris
c) Fitted with appropriate cable glands to maintain the IP rating of the enclosure
selected
d) Fitted with appropriate wall fixings use to secure the unit
2. Ensure that all power is off before connecting any wiring to the controller referring
to connection details in this manual
3. Check all connections are secure upon completion
(1.4) DIP Switches and Functions
(1.4.1) Dead-man / Impulse Operation
With both DIP Sw 1 + 2 OFF, the controller will operate in a hold to run condition, any release
of the control button will stop the motor
Impulse OPEN / Dead-man CLOSE
By moving DIP Sw 1 to ON the controller will operate as Impulse OPEN (one press to run) and
Dead-man CLOSE (hold to run)
Impulse OPEN / CLOSE (one press to run)
By moving DIP Sw 1 + 2 to ON the controller will operate in an Impulse condition (one press to
run), in both OPEN and CLOSE directions
(1.4.2) Emergency Closing
Should a fault develop on the photocell or safety edge circuit, a constant RED 'FAIL' LED will
show when the close button is pressed
However closure is still possible by entering a unique sequence (down, down, down, up, up,
up)
within 6 seconds
- the door can then be brought to the close position by pressing the
CLOSE butto
n
SW 1
Impulse / Dead man - OPEN
Impulse OPEN and CLOSE
Dead man
Impulse
Off
On
Dead man -
Close
Impulse Close
and Open
SW 2
SW 3
Auto Close
Off
Active
Electronic After Run/ Edge Monitoring
Off
Active
Force Control (multiturn)
Off
Active
Force Control (Fine sense)
Off
Active
Not Used - Future option
x
x
Safety Edge - Super fast reverse
Off
0.05 sec's
Safety Edge - Normal (Sw 8 must be OFF)
0.25 sec's
0.1 sec's
Travel Limit Type
Mechanical
Electronic
SW 4
SW 5
SW 6
SW 7
SW 8
SW 9
SW 10
DIP
Function
6
Summary of Contents for V3D Maxi
Page 20: ......
