Ellard V3D Maxi, Product Instructions

Page: 17 / 21

1 2 3
TELECO RADIO RECEIVER CONNECTION
(Ch1) Relay
Mem
To Program - (using Receiver) With the card inserted in the panel and power on
Press and hold
Button "P1"
buzzer will give a
continuous tone Whilst holding
Button "P1"
press and hold Button on
transmitter - buzzer will sound intermittently
Repeat above to program extra transmitters
Low Level Programming - (Using Transmitter)
Press button on rear of transmitter, buzzer will emit a
continuous tone Within 5 seconds press and hold the transmitter button
buzzer will give an intermittent tone Repeat above for other transmitters
To Delete - (Single Transmitters)
Press and hold
Button "P2"
buzzer will give a
continuous tone Whilst holding
Button "P2"
press and hold Button on
transmitter - buzzer will sound intermittently Transmitter is removed from memory
Repeat above to delete other transmitters
To Delete - (All Transmitters)
Press and hold
Button "P2"
buzzer will give a
continuous tone then release Within 0.5 seconds press and hold
Button "P2"
buzzer
will sound intermittently
Keep
Button "P2"
held until buzzer gives a continuous
tone All transmitters have now been erased
(P1) Program Button
(P2) Delete Button
(2.7)Radio Control Operation
Teleco TXP433A02
Radio Transmitter
Teleco RSM434A03
Radio Receiver
Ch1 Button
Program
Button
Door travels to OPEN limit - No stop possible
Press 1
Door stops and RE-OPENS to top position (if traveling)
From fully open position door travels in the CLOSE direction
Press 2 Press 3 Operation starting with door Door at fully CLOSED position
As press 2 etc
Press 4
17