Page 3
2000000557 (Rev. B - 06/22)
LZO8WSN_2A
Figure 1
F
A
C
L
C
E
B
E
D
17-7/8"
(454mm)
7"
(178mm)
7"
(178mm)
6-3/8"
(162mm)
6-3/8"
(162mm)
15"
(381mm)
7/16" X 3/4"
(11mm X 19mm)
OBROUND
HOLES (6)
ACTIVATION
SENSOR
Ø 9/32" HOLES
(7mm)
(12)
2"
(51mm)
2"
(51mm)
2-7/8"
(73mm)
FINISHED
FLOOR
2"
(51mm)
51-9/16"
(1310mm)
38-1/2"
(979mm)
28-13/16"
(732mm)
21-7/8"
(556mm)
19"
(483mm)
17-7/16"
(443mm)
7"
(178mm)
7"
(178mm)
2"
(51mm)
3-7/8"
(98mm)
5-3/4"
(146mm)
32-7/8"
(835mm)
ORIFICE
HEIGHT
31-5/16"
(796mm)
RIM
HEIGHT
5-7/8"
(150mm)
2"
(51mm)
3"
(77mm)
12-1/2"
(318mm)
27"
(686mm)
ADA
REQUIREMENT
HANGER
BRACKET
8-1/16"
(205mm)
19"
(483mm)
3-9/16"
(90mm)
18-7/8"
(479mm)
28-13/16"
(732mm)
13-15/16"
(354mm)
*ADA REQUIREMENT
REDUCE HEIGHT BY 3” (76MM) INCHES FOR INSTALLATION OF CHILDREN’S ACCESSIBLE COOLER
A = Recommended Water Supply Location. Shut Off Valve (not furnished) to accept 3/8” (10mm) O.D. unplated copper tube.
B = Recommended Location for Waste Outlet 1-1/4” (19mm) O.D. drain.
C = 1-1/4” (19mm) Trap not furnished**
D = Unit equipped with IEC C14 socket. Cord not provided. Electrical outlet per local code.
E = Insure proper ventilation by maintaining 6” (152mm) (Min.) clearance from cabinet louvers to wall.
F = 7/16” (11mm) bolt holes for fastening unit to wall.
**New installations must use Ground Fault Circuit Interrupter (GFCI)
Installation: Waste Line connection
1. Install waste trap. Remove the slip nut and gasket from the waste trap and install them on the cooler waste line making sure that the end of
the waste line fits into the waste trap. Assemble the slip nut and gasket to the waste trap and tighten securely.
•
IMPORTANT:
If it is necessary to cut the drain, loosen the screw at the black rubber boot and remove tube, check for leaks after reassembly.
2.
It is recommended that the waste trap be insulated to avoid excessive condensation due to chilled water running through the waste trap.
