ASSEMBLY
OF
THE
CAR
-
ASSEMBLY OF WHEELS
Turn the body down.
1. Slide the gearbox onto the rear axle. The transmission marked "R" should be adapted to the right side of the vehicle body;
2. Move the steering wheel to the rear axle. And keep the bicycle in contact with the transmission.
3. Slide the Ø10 seal onto the rear axle.
4. Tighten the lock nut on the rear
axle end with a wrench.
5. Replace the logo cap
on wheels.
1. Slide the Ø10 seal onto the front axle.
2. Insert the grommet into the hole in the
center of the wheel.
3. Place the wheel on the rear axle.
4. Slide the Ø10 seal onto the front axle.
5. Tighten the lock nut on the front axle
end with a wrench.
6. "Attach" the wheel cover to the wheel.
ASSEMBLY
OF
THE
CAR
-
CONTROL UNIT
,
CONNECTION OF THE REMOTE CONTROL UNIT
Turn the body sideways.
Use a screwdriver to unscrew the M5x22 screw
and Ø5 nut from the remote control unit.
1. Connect the remote control unit to the
gearbox
2. Insert the straight end of the steering rod up
through the hole in the remote control unit, the
hole in the transmission from the bottom and
out through the hole in the instrument panel.
3. Align the holes on the remote control unit
and the hole in the steering rod, tighten the
M5x22 screw and the Ø5 nut back to the same
place.
4. Insert the bent end of the steering rod
through the hole in the front axle.
5. Install a Ø10 seal on the bent end of the
steering rod.
6. Insert the pin into the hole in the steering
rod, bend the ends with long pliers (not
included).
