Drawing:
1. Front Grill
8. Screws
2. Blade
9. Spinner (Blade Knob)
3. Plastic Nut
10. Base
4. Rear Grill
11. Speed Control Buttons
5. Motor Shaft
12. Tighten - turn to left
6. Oscillation Knob 13. Loosen - turn to right
7. Fan Body
PART 1:
1. Insert the Fan Body assembly into the base.
2. Secure by putting the 4pcs of screws provided into the holes under
the base cover.
3. Tighten the screws fully in the base but do not over tighten.
PART 2:
ASSEMBLY
1. Unscrew the spinner (blade knob) clockwise and the nut counter
clockwise and remove both of them.
2. Set the rear grill in the proper position with the handle up.
3. Screw on plastic nut tightly to attach rear grill.
4. Discard plastic sleeve on shaft.
5. Install the blade onto the shaft until the retaining pin fits into the
notch on the blade.
6. Screw spinner (blade knob) to the motor shaft counter clockwise
(tighten by turning to the left)
7. Mount
Front Safety Grill
onto
Rear Grill
by hanging the top hook
clip of front
guard over the top of the
Rear Grill
. Tighten the safety screw and
close the clasps all around the grill.
PART 3:
BOPERATION
• Place your fan on a level and dry surface.
• Plug the power cord into AC220-240V wall outlets.
Speed Control
Speed is controlled by the button switch.
