V700L Managed Single Master / Slave LAN Extender
USER’S MANUAL Ver. B.2
9
Ethernet Port interface : RJ-45
All network connections to the modem Ethernet port must be made using Category 5 UTP/STP or above for
100 Mbps, Category 3, 4 UTP for 10Mbps.
No more than 100 meters of cabling may be use between the MUX or HUB and an end node.
VDSL2 Port interface : RJ-11 & Terminal block combo
All network connections to the RJ-11/ terminal block(sharing port) must use
24~26
gauge with single
twisted pair
phone wire.
We
do not recommend
the use of the 28 gauge phone wire or above.
The RJ-11 is an 6P2C connector, two of which are wired. The modem uses the center two pins. The pin out
assignment for these connectors is presented below.
Please note that the line port is no polarity, therefore user can reverse the two wires of the phone cable
when installed.
RJ-11 Pin out Assignments
Pin#
MNEMONIC
FUNCTION
1
NC
Unused
2
NC
Unused
3
DSL
Used
4
DSL
Used
5
NC
Unused
6
NC
Unused
2.4 Connecting the RJ-11 / RJ-45 Ports
The line port have 1 connector: RJ-11 . It is used to connect with V700L Master side over a single pair phone wire to V700L
